Skip to content
gunkslab

Guides

Safety sheet

For anyone putting real bots on a desk or a classroom table. It fits on one page, so print it. The reasons are on Safety, and every way a bot stops is on Every stop.

Stop a bot

  • Pick it up, or switch it off. That is the stop to count on. No bot has been tested on a finished car yet.
  • The e-stop on the page is a message over Wi-Fi. If the Wi-Fi, the broker or the computer is down, it can’t arrive. Everyone has their own, and every bot stays stopped while anyone’s is on. Clear yours, then send a fresh command.
  • Commands expire in 500 ms. A bot that hears nothing for half a second stops by itself. Closing the tab stops a bot you’re driving by hand. A go-to keeps going, because the station steers it.
  • The reflex, where fitted. With its distance sensor, a bot won’t drive forward into something close or off the desk’s edge. It has been checked in the simulator, not on a real sensor yet. Don’t rely on it.

Batteries

  • Charge a pack with a charger made for it, where you can see it. Never leave it charging alone or overnight.
  • Use a balance charger on a 2S pack. Keep the pack’s protection board in place.
  • Don’t short, crush, pierce or overcharge a pack. Don’t run it flat. A pack run below its empty voltage can be damaged, and is risky to charge again.
  • Retire a damaged pack. Swollen, dented, hot, leaking or smelling odd: stop using it and take it to battery recycling. Don’t charge it or put it in the bin.
  • Unplug the pack from the bot when you put it away. Store it somewhere cool and dry, away from things that burn.

More in Batteries.

The table

  • Put the bots on a table with a clear edge, and keep them off the floor you walk on.
  • Sit the bots on the desk first, then start them. The reflex isn’t proven, so keep a hand near the edge.
  • Keep low things a centimetre or two clear of a bot’s path. Its sensor can miss them (Known issues).

People

  • Hair tied back, sleeves and cords clear. Fingers stay out of the wheels.
  • Never reach for a moving bot. Stop it first.
  • Small parts and screws can be swallowed. Keep them away from young children, and count them after a build.
  • Children use it with an adult in the room.

When a bot misbehaves

  1. Stop it: pick it up or switch it off. Don’t chase it.
  2. Press the e-stop on the page.
  3. Take the pack off the bot.
  4. A bot that is hot, smoking or smelling odd goes on a hard surface, away from anything that burns. Keep people back.
  5. Write down what it did, then see Troubleshooting. Report it at gitlab.com/gunkslab/desk-issues.